Mueller U-Panel Manuel d'utilisateur télécharger pdf (Page 27)

CHIMNEY INSTALLATION

CHIMNEY FLASHING - SIDE

FLASHING - VENT

Procedures:

1. Trim the opening in the flashing to 20% smaller than

the pipe diameter.

2. Slide the flashing down over the pipe.

3. Seal between the flashing and the roofing with

tube caulk and set the flashing.

4. Form the flashing to fit the profile of the roof.

5. Fasten the flashing with woodgrip screws 1” on centers.

NOTE: Alternate trim profiles are acceptable using the

screw pattern shown.

NOTE: In many cases it may be easier to locate

vent/pipe flashing in the flat area of the roof panel

(as shown) rather than have the penetration occur

at a panel rib. Determining panel layout prior to

installation often simplifies flashing installation.

1. Trim and bend the right side flashing as indicated.

2. Trim the left side in a similar fashion.

NOTE: Alternate trim profiles are acceptable using the

screw pattern shown.

NOTE: The left and right side flashing are mirror

images of each other.

SIDE

Installations apply to both R & U-Panels. R-Panel shown in illustration.

1 2 ... 22 23 24 25 26 27 28

Pas de commentaire

Mueller U-Panel Manuel d'utilisateur Page 27